This website uses cookies to ensure you get the best experience on our website. Read our cookie policy
SKU
53546-021APO
£64.57 £53.81
Apollo Series 65 Conventional Duct Smoke Detector - 53546-021APO
- Buy 20 for £64.13 £53.44 each and save 1%
- Buy 50 for £63.61 £53.01 each and save 1%
The Conventional Duct Smoke Detector provides early detection of smoke in the air moving through heating and ventilation (HVAC) ducts in commercial and industrial premises. Its purpose is to prevent the re-circulation of smoke from an area on fire to areas unaffected by the fire when used with a Series 65 or Orbis detector. It provides a volt-free changeover relay rated at 30V, 1A.
Operation
The duct smoke detector is fitted to the side, the top or the bottom of the ventilation duct and has two tubes which extend into the air duct through holes in the duct wall. The perforated sampling tube which spans the duct is placed in the airflow upstream of the exhaust tube which causes a pressure differential in the duct detector. Air is sucked up the sampling tube, across the detector and exhausted back into the air duct.
The duct smoke detector is designed to operate in ducts with a width of between 300mm and 3000mm. A sampling tube of 360mm, suitable for duct widths up to 540mm, is supplied as standard. Longer sampling tubes for wider ducts may be ordered separately:
150—750mm Part no 53541-170
750—1500mm Part no 53541-171
1500—3000mm Part no 53541-172
The tubes should be long enough to reach from one side of the duct to the other and it may be necessary to use a tube that is too long and cut it to slightly more than the duct width. Since the tube needs to be supported on both sides a hole should be cut in the opposite wall of the air duct to allow the tube to protrude slightly. The tube must be closed with the small red bung provided.
The exhaust tube does not need to extend across the duct and is therefore supplied at a fixed length.
Additional Information
Duct smoke detector part no 53546-021 is designed to accept a conventional detector head. The following heads may be used:
1. Orbis
Optical smoke ORB-OP-12001
2. Orbis with flashing LED
Optical smoke ORB-OP-12003
3. Series 65
Ionisation smoke 55000-217
Optical smoke 55000-317
4. Series 65 with flashing LED
Ionisation smoke 55000-216
Optical smoke 55000-316
Electrical Description
The duct smoke detector is supplied as a housing with a base fitted for either a conventional detector or an analogue addressable detector. The housing has provision for electrical connections depending on the type of detector fitted. For technical data on the detector head, please refer to the relevant product guide or PIN sheet.
Watch the Video
Key Features |
---|
> For use with Series 65 or Orbis detectors (sold separately) > Operates in air speeds of 0.5m/s to 20m/s > Transparent cover to view detector head LED > Integral smoke test port > Volt-free contacts |
Manufacturer | Apollo Fire Detectors |
---|---|
MPN | 53546-021APO |
Write Your Own Review
Sort By:
No questions yet. Be the first to ask the question!