Advanced MXP-509 MxPro 5 Fault Tolerant Network Card

SKU
MXP-509
£538.78 £448.98
Advanced MXP-509 MxPro 5 Fault Tolerant Network Card

The Advanced MXP-509 is a fault tolerant network card for MxPro 5 fire alarm control panels.

The Ad-NeT network system allows all MxPro 5 series control panels, remote terminals and network peripherals to be connected together using standard fire resistant two-core cable. It provides both the benefits of distributed intelligence and reduced installation costs whilst catering for the smallest two-panel network through to the largest 200-panel wide area networked system.

The network operates as a true peer-to-peer system allowing information from any input or output device to be passed over the network and displayed on any MxPro 5 control panel or remote terminal as required.

Simply adding and connecting a network card allows any MxPro 5 control panel or remote terminal to be networked. All other nodes on the Ad-NeT system will be instantly aware of a panel as soon as it is given a valid network node address, allowing additional panels to be added at any time. All panels incorporate a network analyser providing valuable diagnostic and status information and also have the facility to prevent the transmission of fires or faults during commissioning.

For more complex systems, the Windows-based PC-NeT Mx configuration software allows sector based programming for Mute, Silence, Resound and Reset control keys as well as investigation delays, group disablement and test instructions. All panels within the same sector will share common controls and each panel or remote terminal can also be programmed to show specific network information on a zonal basis. For cause and effect, any input device can be programmed to operate any output device on any panel.

Limitations

The maximum cable length is 1.5km between each node, and the maximum total loop length is 20km. Each network card has inbuilt diagnostics and is fully monitored for both short and open circuit faults between nodes. The network is capable of withstanding a single fault between nodes without loss of communications to any single panel. The maximum number of network nodes is 200.


Key Features
> Fault tolerant network card for MxPro 5 panels
> Large Ad-NeT+ 200 Panel Network
> Up to 1.5Km between Control Panels
> Windows based PC setup
> Network Systems share up to 1000 zones
> Network Analysis from Contol Panel
More Information
ManufacturerAdvanced Electronics
MPNMXP-509
Write Your Own Review
You're reviewing:Advanced MXP-509 MxPro 5 Fault Tolerant Network Card
Your Rating
Loading...

Sort By: 

Ask Question

All questions will be displayed after moderation.

No questions yet. Be the first to ask the question!
Network ConnectionsIN: A/B SCN(Screen)
OUT: A/B SCN (Screen)
On-board Indication2 Red LED’s.
LED 1 illuminates when data is transmitted
LED 2 illuminates when data is received
Supply Current61mA
(All power is taken directly from the panel motherboard)
Temperature range and Humidity-5°C to 40C
95% non-condensing (maximum)
Dimensions
(H x W x D)
85mm x 65mm x 20mm
(Mounting pillars are provided on the panel chassis to mount this card)
Recommended Cable2 Core twisted-pair plus screen
Advanced MXP-509 MxPro 5 Fault Tolerant Network Card